Description
The air slide fabric is made of high-quality synthetic temperature-resistant fiber, which is suitable for the pneumatic conveying chute of cement, alumina and other powders. It is often used to transport cement and raw meal powder in the cement industry.
Let's to know how to install the air slide fabric in the air conveying chute
1. When installing the air conveying chute, the slope should be strictly guaranteed. The upper and lower tank joint flanges are used as the reference plane, and the tolerance is 1/1000 (the accumulation error should be along the increasing slope direction). The horizontal unevenness tolerance of the tank is 1/500 of the width.
2. The air slide fabric should be stored in a clean and dry place. Do not stick to oil when installing. When cutting, the length of the air slide fabric is 0.5m longer than the slope, and the width is 1.5cm wider than the flange of the casing. After the longitudinal tension, the upper casing is installed. At this time, the lateral direction is also tightened as much as possible. When there are curved grooves and three-way and four-way grooves, in order to maintain uniform gas permeability, the interlayer joints are staggered and the joints are tight. When installing, first install the upper part of the joint and then tighten the ends.
2. The breathable cloth should be stored in a clean and dry place. Do not stick to oil when installing. When cutting, the length of the breathable cloth is 0.5m longer than the slope, and the width is 1.5cm wider than the flange of the casing. After the longitudinal tension, the upper casing is installed. At this time, the lateral direction is also tightened as much as possible. When there are curved grooves and three-way and four-way grooves, in order to maintain uniform gas permeability, the interlayer joints are staggered and the joints are tight. When installing, first install the upper part of the joint and then tighten the ends.
4. Check and adjust the parts such as inspection door, three-way trough, four-way trough, peek window and air-cut valve to make it flexible during operation. When closing, the rubber shutter of the air shutoff valve should be repeatedly shaped in contact with the inclined air slide fabric to make an agreement.
The above is the installation knowledge of the air chute canvas introduced for you, and I hope to help everyone in the production work. Welcome to consult, email: [email protected].
